首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   467篇
  免费   13篇
  国内免费   6篇
测绘学   38篇
大气科学   59篇
地球物理   62篇
地质学   187篇
海洋学   45篇
天文学   70篇
综合类   4篇
自然地理   21篇
  2021年   6篇
  2020年   4篇
  2018年   20篇
  2017年   20篇
  2016年   17篇
  2015年   13篇
  2014年   16篇
  2013年   29篇
  2012年   13篇
  2011年   26篇
  2010年   12篇
  2009年   32篇
  2008年   16篇
  2007年   23篇
  2006年   25篇
  2005年   15篇
  2004年   14篇
  2003年   19篇
  2002年   19篇
  2001年   18篇
  2000年   8篇
  1999年   11篇
  1998年   9篇
  1997年   11篇
  1996年   2篇
  1995年   2篇
  1994年   5篇
  1993年   2篇
  1992年   3篇
  1991年   5篇
  1989年   2篇
  1988年   4篇
  1987年   12篇
  1986年   2篇
  1985年   7篇
  1984年   4篇
  1983年   2篇
  1982年   4篇
  1980年   3篇
  1978年   3篇
  1976年   2篇
  1975年   2篇
  1974年   3篇
  1973年   3篇
  1971年   2篇
  1959年   1篇
  1958年   1篇
  1957年   1篇
  1955年   1篇
  1950年   1篇
排序方式: 共有486条查询结果,搜索用时 15 毫秒
111.
112.
It is shown that the microstructures of the antiperthites of the South Norwegian anorthosites strongly suggest an exsolution origin. In addition to the normal exsolution reactions responsible for most antiperthites, exsolution of potash feldspar in plagioclase may occur by a discontinuous mode of precipitation.  相似文献   
113.
The flow relaxation scheme (FRS) is tested as an open boundary condition (OBC). This scheme was originally designed to relax external solutions (ES) from a large area model towards solutions in a limited area model with a fine mesh. When one uses the FRS as a pure OBC; i.e. the ES are unknown and set equal to zero, the FRS method degenerates to a sponge type OBC. Since a sponge type OBC does not work well in all cases, for instance in the case of an alongshore uniform wind; Chapman (1985) and Røed and Cooper (1987), we introduced local wind induced solutions as a part of the ES.When we also included the tide in the ES, the tests showed that the FRS method handled the tidal input problem very well. Even in the case where noise was added to the tide in the ES, the results were good.The major drawbacks for the FRS method are the required extention of the computer-space and -time.  相似文献   
114.
Located in northern Québec, the Lac Shortt Mine was a small gold mine consisting of a thin subvertical orebody which was mined in three main phases. High stress and rockbursting conditions were experienced when ore was extracted in the upper zone between the surface and a depth of 500 metres during the first two phases of mining. Severe rockbursts were experienced in late 1989 near the shaft and in the footwall development following a deepening of the mine shaft to a depth of 830 m and partial development of footwall drift access for the third phase of mining (the mining of the lower zone starting at a depth of 830 m moving upward toward a depth of 500 m). A 16-channel Electrolab MP250 microseismic system, with a Queen's University Full-Waveform piggy-back system, was installed underground at the site due to these problems.It was expected that the thinning sill would be subjected to an ever-increasing load as the thickness of the 500 m sill pillar decreased in the face of the mining excavation from below. A monitoring program consisting of the microseismic monitoring system, a range of conventional geomechanics monitoring tools as well as the undertaking of periodic seismic tomography surveys to assess the ongoing state of stress and rock mass condition within the sill was therefore warranted.The anomalously high-magnitude stress field and the brittle rockmass created a situation in which rockmass failure was common and violent. In the creation and thinning of the sill pillar, the location of banded microseismic activity was crucial in tracing rockmass failure and the associated ground control problems. Reliable source-location determination enabled the identification of areas of stress increase. The movement of the rockmass failure front could be followed, and was responsible for stope dilution, footwall and orebody development deterioration, and caving.Source-mechanism analyses gave accurate double-couple solutions for approximately forty percent of these events having at least ten recognizable polarities. Results suggested movement along vertical north-south striking or vertical east-west striking features. Underground observation of damaged access points showed that vertical north-south striking joints were experiencing failure.The microseismic activity, which was consistently concentrated close to the southwest and northeast corners of current production stopes, could be explained by a stress field oriented obliquely to the strike of the orebody, as measured prior to shrinkage of the sill pillar byin situ stress measurements and observed borehole overbreaks. The orientations of theP andT axes for the microseismic activity further confirmed that the stress field oriented obliquely to strike.While an increase in compressional-wave velocity of 2.3 percent, corresponding to a measured stress increase of approximately 10 MPa could be measured by repeated tomographic surveys, it was relatively small and only a factor of two or so above the velocity measured uncertainty. The relative insensitivity of thein situ rock mass modulus to the applied stress is believed to be largely due to the rockmass discontinuities being relatively closed prior to stress increase, as substantiated by the small deformations seen by the extensometer and borehole camera. This situation existed because of the very high pre-mining stress level.The experimental demonstration that the rock could not absorb substantially increased load through the mechanism of discontinuity closure or tightening (which would be reflected in the modulus) may be evidence in itself of potentially burst-prone ground, such as encountered at Lac Shortt.  相似文献   
115.
Carbon, nitrogen, and phosphorus flow networks, consisting of 59 compartments, were constructed for the Sylt-Rømø Bight, a large shallow sea in the German Wadden Sea. These networks were analysed using ecological network analysis. Each network depicts the standing stock of each component in the ecosystem, and the flows between them. The trophic efficiency by which material is utilised in the Bight increase from 3%, to 6% to 17% for C, N and P, respectively. The number of cycles though which these elements pass increase from 1 197 for carbon, to 414?744 and 538?800 for nitrogen and phosphorus, respectively. The Finn Cycling Index, reflecting the amount of material recycled as a fraction of the total system activity, TST, increases from 17% for carbon, to 43% for nitrogen, to 81% for phosphorus. Other system level attributes such as the Average Path Length, the Average Internal Mutual Information, Relative Ascendancy, Relative and Normalized Redundancy, show an increase from the carbon to the nitrogen to the phosphorus networks. Phosphorus is tightly cycled over longer pathways than the other two elements, and also has the longest residence time in the Bight. Postulated differences between the behaviour of energy (or carbon) and biogeochemical networks in coastal ecosystems are evident from the results obtained from ecological network analysis.  相似文献   
116.
The Schleenhain open pit coal mine, located 30 km south of Leipzig, Germany, exposes Upper Eocene and Oligocene non-marine strata representing fluvial deposition in the centre of the Weisselster Basin. Active mining and successive cuts provided the rare opportunity to obtain a three-dimensional perspective of laterally extensive surface outcrops. These were used to construct a detailed fence diagram, which provided the basis for recognition of key architectural elements in the weakly consolidated meandering stream deposits. In addition to the eight basic architectural elements of Miall (1985 ), the element SL (shallow lake deposits) was newly defined and the element CH (channel) was subdivided into CHg (palaeo-river system) and CHk (small channel). The profiles contain parts of two fining-upward cycles, which are separated by an unconformity spanning the Early Oligocene. Deposits of the first cycle begin with transverse sand bars (downstream accretion deposits-DA) and point bars (lateral accretion deposits-LA). The upper part of the cycle is represented by overbank fines (OF) and the element SL, which consists of laterally discontinuous lenses of dark, plant-bearing, kaolinite-rich clays, that were deposited in shallow lakes adjacent to the active channel. Coal seams interlayered with palaeosols are the main constituents of element OF. Sheetlike bodies of medium to fine gravels (gravel bars and bedforms-GB) on an erosive coal surface mark the beginning of the second cycle. Dissolution of underlying Permian salts and sulphates prior to, during, and after the deposition of the Palaeogene strata caused the development of two synclines within the outcrop. Coal seams and clay horizons which thicken and dip towards the centre of the synclines, provide evidence for their chronological development.  相似文献   
117.
118.
119.
Nonphysical pressure oscillations are observed in finite element calculations of Biot's poroelastic equations in low‐permeable media. These pressure oscillations may be understood as a failure of compatibility between the finite element spaces, rather than elastic locking. We present evidence to support this view by comparing and contrasting the pressure oscillations in low‐permeable porous media with those in low‐compressible porous media. As a consequence, it is possible to use established families of stable mixed elements as candidates for choosing finite element spaces for Biot's equations. Copyright © 2011 John Wiley & Sons, Ltd.  相似文献   
120.
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号